1975 Datsun 280z FSM - Spooled up Racing

Body Electrical System
RADIO
DESCRIPTION
The radio system consists of antenna,
speaker, radio receiver and antenna
switch.
Antenna is connected to radio
receiver with feeder cable. Speaker is
connected to radio receiver with pair
of speaker harnesses. Radio receiver is
installed on console box.
Speaker is installed behind L.H.
side body rear trim.
Antenna trimmer adjustment is
required for best radio performance.
A fuse is added on harness midway
from ignition switch.
Antenna switch is installed on radio
receiver.
Knob
Escutcheon
Radio receiver
Antenna switch
Fuse
Antenna feeder cable
BE157A
Fig. BE-132 Removing radio receiver
REMOVAL AND
INSTALLATION
Radio receiver
1. Remove console box referring to
Section BF.
2. Disconnect lead wires for radio
and antenna switch at two connectors.
Feeder cable is also removed.
3. Pull out dials on radio receiver
and remove two nuts retaining escutcheon
to radio receiver.
4. Remove two screws retaining
radio receiver to console box. Radio
receiver can then be taken out.
5. Installation is in the reverse sequence
of removal.
1
2
3
Fig. BE-133
Dow
9
6
UP
o
6
BE158A
Antenna switch
Antenna switch
1. Remove console box and escutcheon
as previously described.
2. Remove antenna switch retaining
screw and switch can then be taken
out from radio receiver.
3. Installation is in the reverse sequence
of removal.
Antenna
1. Remove antenna upper retaining
nut and remove retainer from outside
of rear fender.
2. Remove side body rear panel and
disconnect lead wires at connectors.
Fig. BE-134
BE159A
Antenna
BE-76