1975 Datsun 280z FSM - Spooled up Racing

FRONT
COMBINATION LAMP
Body Electrical System
BULB REPLACEMENT
1. Remove two screws and remove
lens.
2. Push in on bulb, twist it counterclockwise,
and remove it from socket.
3. Insert new bulb into socket, press
it inward and rotate it clockwise. Make
sure that the bulb is locked in socket.
Bulb wattage
Front combination lamp
Turn/Clearance' 23W/8W
1 Lens
2 Limb
3 Lamp body
4 Bulb
LAMP BODY REPLACEMENT
1. Disconnect connector for front
combination lamp behind lamp body.
2. Remove front combination lamp
cover by removing two screws.
3. Remove screws retaining lamp
body to front grille from front of the
panel and remove front combination
lamp.
4. Installation is in the reverse sequence
of removal.
SIDE MARKER LAMP
BULB REPLACEMENT
1. Remove two lens retaining
screws.
2. Remove lens from lamp body.
3. Push in on bulb, twist it counterclockwise
and remove from socket.
4. Insert new bulb into socket, press
it inward and rotate it clockiwse. Make
sure that bulb is locked in socket.
5. Install lens in the reverse
sequence of removal.
BE615A
Fig. BE-29 Front combination lamp
Bulb wattage:
Side marker lamp
8W
LAMP BODY REPLACEMENT
1. Disconnect lead wire at a connector
(front) or at two connectors
(rear).
2. Remove two lens retaining screws
and take out Lmp body assembly.
3. Install r, .mp body assembly
in the reverse sequence of removal.
Front
Rear
1 Lamp body
2 Adapter
3 Bulb
4 Lens
5 Limb
BE-23
BE986
Fig. BE-30 Side marker lamp