PowerFlex 750-Series AC Drives User Manual

3-42 Programming and ParametersDrive Cfg FileFileGroupNo.NameDescriptionValuesRead-WriteData Type300 Speed UnitsSpeed UnitsSelects the units to be used for all speed related parameters. Options 0 and 1 donot convert other parameter values (e.g. a 60 Hz reference becomes 60 rpm).Options 2 and 3 perform an automatic conversion of other parameter values (e.g.a 60 Hz reference becomes 1800 rpm, based on motor nameplate settings).This parameter is only reset when Set Defaults “All” (not recommended) isexecuted.Default:Options:Current Selection0 = “Hz”1 = “RPM”RW 32-bitIntegerDRIVE CFGPreferences301 Access LevelAccess LevelSets the access level for parameters and option choices.“Basic” (0) – Provides the smallest, simplest, and most user friendly view.“Advanced” (1) – May be required to use advanced features.“Expert” (2) – Not normally recommended (makes the list very long), and showsextra parameters that should rarely be required.When the access level is changed, PC-based tools (e.g. Drive Tools and DriveExplorer) will require a reconnect.This parameter is only reset when Set Defaults “All” (not recommended) isexecuted.302 LanguageLanguageSelect display language.This parameter is only reset when Set Defaults “All” (not recommended) isexecuted.Default:Options:Current Selection0 = “Basic”1 = “Advanced”2 = “Expert”RW 32-bitIntegerDefault:Options:0 = “Not Used”0 = “Not Used”1 = “English”2 = “French”3 = “Spanish”4 = “Italian”5 = “German”6 = “Japanese”7 = “Portuguese”8 = “Chinese”9 = “Reserved”10 = “Reserved”10 = “Korean”RW 32-bitIntegerPowerFlex 750-Series User Manual – Publication 750-UM001C-EN-P – September 2009