PowerFlex 750-Series AC Drives User Manual

Index-3PParametersAdvanced View 3-5Basic View 3-3Cross Reference 3-131Defaults D-6, D-8Descriptions and Programming 3-1DeviceLogix G-3Drive Applications File 3-109Drive Cfg File 3-42Drive Communication File 3-95Drive Diagnostics File 3-100Drive Feedback & I/O File 3-28Drive Monitor File 3-19Drive Motor Control File 3-20Drive Position Control File 3-83Drive Protection File 3-54Drive Speed Control File 3-62Dual Incremental Encoder 3-161EtherNet 3-178Expert View 3-10I/O Module 3-137Linear List 3-19On Option Modules 3-15Organization 3-3Safe Speed Monitor Module 3-148Single Incremental Encoder 3-159Universal Feedback Module 3-166PE (Grounding) 1-9PE-A and PE-B Jumpers 1-23Permanent Magnet Motors H-1Plugs 1-21Pollution Degree Ratings A-7Ports and Devices A-4Ports, DPI 2-2PowerConditioning 1-8Jumper Screw Removal 1-25Jumper Wire Removal 1-26Jumpers 1-23Single-Phase 1-14Terminal Blocks 1-14Wiring 1-11Precautions, General p-4RRatings, Drive A-11RCD (Residual Current Detector) 1-8Real Time Clock Battery 1-31, 1-33Recommended Grounding Scheme 1-9Regenerative Power Units 1-23Reset Parameter ValuesDrive D-6Peripherals D-8Residual Current Detector 1-8Resistance, Minimum Values A-6Resistor, Brake 1-22RFI Filter 1-10SSafe Speed Monitor Module 1-45Safe Torque Off Module 1-44Safety Enable Circuitry 1-35Safety Ground 1-9Servo Motors H-1Shielded Cables, Power 1-12SHLD Terminal 1-9SpecificationsAgency Certification A-1Control A-3Drive Ratings A-11Electrical A-3Environment A-2Protection A-1Start Up 2-1Check List 2-1Menu 2-3Navigating To Menu D-4Status Indicators 2-4, 4-2Supply Source 1-8Support p-2TTechnical Support p-2Contacting 4-22Terminal BlocksLocation 1-15, 1-18Power 1-17, 1-20Wire Size, I/O 1-28Wire Size, Power 1-14THHN and THWN Wire Coatings 1-12Troubleshooting 4-1Common Symptoms 4-20PowerFlex 750-Series User Manual – Publication 750-UM001C-EN-P – September 2009