PowerFlex 750-Series AC Drives User Manual

Chapter 2Start UpThis chapter provides the information needed to start up the PowerFlex750-Series drive.For Information on … See Page ...Establishing A Connection With EtherNet/IP 2-5Prepare For Initial Drive Start-Up 2-1Start-Up Menu 2-3Drive Status Indicators 2-4Start-Up Check List • This check list supports the Start-Up menu option.• A Human Interface Module (HIM) is required to run the Start-Uproutine.Important: Appendix D provides an overview of Human InterfaceModule (HIM) display elements and menu navigation.• The Start-Up routine may modify parameter values for Analog andDigital I/O.!ATTENTION: Power must be applied to the drive to performthe following start-up procedure. Some of the voltages presentare at incoming line potential. To avoid electric shock hazard ordamage to equipment, only qualified service personnel shouldperform the following procedure. Thoroughly read andunderstand the procedure before beginning.Prepare For Initial Drive Start-Up❏❏❏1. Confirm that all inputs are connected to the correct terminals and aresecure.2. Verify that AC line power at the disconnect device is within the ratedvalue of the drive.3. Verify that control power voltage is correct.PowerFlex 750-Series User Manual – Publication 750-UM001C-EN-P – September 2009