PowerFlex 750-Series AC Drives User Manual

3-48 Programming and ParametersFileGroupNo.NameDescription350 Sleep Wake ModeSleep Wake ModeEnables/disables the Sleep/Wake function.Important: When enabled, the following conditions must be met:• A proper value must be programmed for 352 [Sleep Level] and 354 [WakeLevel].• A sleep / wake reference must be selected in 351 [SleepWake RefSel].• At least one of the following must be programmed (and input closed) in P155[DI Enable], P158 [DI Stop], P163 [DI Run], P164 [DI Run Forward], or P165[DI Run Reverse].ValuesDefault:Options:Read-WriteData Type0 = “Disabled”RW 32-bit0 = “Disabled”Integer1 = “Direct” (Enabled)2 = “Invert” (Enabled) (7)!ATTENTION: Enabling the Sleep/Wake function can cause unexpected machine operation during the Wakemode. Equipment damage and/or personal injury can result if this parameter is used in an inappropriateapplication. Do Not use this function without considering the information below. In addition, all applicablelocal, national, and international codes, standards, regulations, or industry guidelines must be considered.DRIVE CFGStart FeaturesInputStopEnableAfter Power-Up After a Drive Fault After a Stop CommandReset by Stop-CF,HIM or TBStop ClosedStop ClosedWake SignalWake SignalNew Start or Run Cmd. (4)Enable ClosedWake Signal (4)Run Run ClosedRun For. Wake SignalRun Rev.Reset by ClearFaults (TB)HIM or TBStop Closed Stop ClosedWake Signal Direct ModeNew Start or Run Cmd. (4) Analog Sig. > Sleep Level (6)Invert ModeAnalog Sig. < Sleep Level (6)New Start or Run Cmd. (4)Enable Closed Enable Closed Enable ClosedWake SignalWake Signal Direct ModeNew Start or Run Cmd. (4) Analog Sig. > Sleep Level (6)Invert ModeAnalog Sig. < Sleep Level (6)New Start or Run Cmd. (4)New Run Cmd. (5)Wake SignalRun ClosedWake SignalNew Run Cmd. (5)Wake Signal(1)When power is cycled, if all of the above conditions are present after power is restored, restart will occur.(2)If all of the above conditions are present when [Sleep-Wake Mode] is “enabled,” the drive will start.(3)The active speed reference. The Sleep/Wake function and the speed reference may be assigned to the same input.(4)Command must be issued from HIM, TB, or network.(5)Run Command must be cycled.(6)Signal does not need to be greater than wake level.(7)For Invert function, refer to P53/63 [Anlg InX LssActn] on the I/O module.351 SleepWake RefSelSleep Wake Reference SelectSelects the source of the input controlling the Sleep-Wake function.Default:Min/Max:0 (Disabled)0 / 159999352 Sleep LevelSleep LevelDefines the analog input level that will stop the drive.Units:Default:Min/Max:353 Sleep TimeSleep TimeUnits:Default:Secs0.00Defines the amount of time at or below 352 [Sleep Level] before a Stop is issued. Min/Max: 0.00 / 1000.00VAC, P351 = 0 (Disabled)VAC or mA, P351 = not 0 (Port X DeviceJumper Setting)5.00 VAC (P351 = 0)5.00 VAC / 0.00 mA (Port X DeviceJumper Setting)0.00 / 10.00 VAC0.00 / 20.00 mARW 32-bitIntegerRW RealRW RealPowerFlex 750-Series User Manual – Publication 750-UM001C-EN-P – September 2009