PowerFlex 750-Series AC Drives User Manual

D-6 Human Interface Module (HIM) OverviewSetting Factory DefaultsSetting PowerFlex 750-Series Drives to Factory Defaults1. Access the Status screen (Figure D.6).2. Use the or key to scroll to the Port 00 for the Host Drivewhose settings you want to reset to factory defaults.3. Press the key to display its last-viewed folder.4. Use the or key to scroll to the MEMORY folder.5. Use the or key to select Set Defaults.6. Press the (Enter) key to display the Set Defaults pop-up box.Figure D.11 Set Defaults Pop-Up Box for PowerFlex 750-Series DrivesStoppedAUTO0.00 HzFPort 00: Set DefaultsHost and Ports (Preferred)This Port OnlyESCINFO7. Use the or key to select the appropriate action.– Host and Ports (Preferred): Selects the Host device and all ports for afactory default action.– This Port Only: Selects only this port for a factory default action.TIP: For a description of a selected menu item, press the INFO soft key.8. Press the (Enter) key to display the warning pop-up box to resetdefaults.Figure D.12 Host and Ports (Preferred)Pop-Up BoxFigure D.13 This Port Only Pop-UpBoxStopped0.00 HzAUTOFWARNINGSets most parameters in theHost device and all ports tofactory defaults. Continue?ESCENTERStopped0.00 HzAUTOFWARNINGUse MOST to reset typical ▲settings on this port(preferred). Use ALL toreset all settings.▼ESC ALL MOSTPress the ENTER soft key to affirm and set mostparameters for the Host Drive and port devices tofactory defaults. In this case, refer to Table D.A forthe settings that will NOT be restored. Or pressthe ESC soft key to cancel.Press the MOST soft key to set MOST settingsfor the selected port device to factory defaults.In this case, refer to Table D.A for the settingsthat will NOT be restored. Press the ALL softkey to set ALL settings for the selected portdevice to factory defaults. Or press the ESCsoft key to cancel.PowerFlex 750-Series User Manual – Publication 750-UM001C-EN-P – September 2009