CANoe DENoe - KEMT FEI TUKE

92
If you work without a real bus and real controllers, you can operate CANoe in pure
simulation mode. Switch the operating mode in the simulation dialog (Menu item
Configuration│Simulation...) from Real Bus to Simulated Bus. Bus access (sending
and receiving messages) is then simulated.
In simulation mode an animation factor can be specified. The (simulated) measurement
then appears slowed by this factor. Accordingly, the simulation is accelerated
for simulation factors between zero and one. (For example, if you specify the
value 0.1, the measurement would be accelerated by a factor of 10.)
The supplemental icons and appearing on the toolbar can be used to resume
the simulation for a defined period of time or to stop a running simulation at any point
in time. The length of the time step is set in the input box to the right of the icons; input
is in milliseconds.
Slave mode is a special simulation mode in which the time sequencing of the measurement
(time base) is controlled by an external program. A typical usage would be to
control the measurement by a master program which accesses the CANoe simulation
object via the COM.
CAPL Debugging enables the display of variables of CAPL nodes during a CANoe
simulation as well as stopping simulations by the use of CAPL commands.
This dialog allows settings for:
• Activating/deactivating the execution of the halt CAPL command.
(default: activated)
The execution of all halt commands within a CANoe configuration can be enabled/disabled.
• Activating/deactivating the display of the full path in the call stack
(default: deactivated)
You can select whether the call stack shows only the name of the CAPL node
or the full path.
• Activating/deactivating the execution of the inspect CAPL command
(default: activated)
The execution of all inspect commands within a CANoe configuration can be
enabled/disabled.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1