CANoe DENoe - KEMT FEI TUKE

Furthermore, the panel configuration dialog also offers you the option of selecting
certain panels which should remain permanently open, i.e. should not be influenced
by the actions of panel control. Simply enter the particular panels in the
list of permanently opened panels. On the one hand, these may include the
control panels themselves, which should not be closed. Of course, on the other
hand you can also enter important display and control panels here which must
constantly remain open.
In the panel configuration dialog you can also enter panel groups for the two
predefined events Measurement start and Loading/Measurement stop. Panel
control opens the particular panel when the event occurs, just as though you
had pressed the particular configured panel control pushbutton. Here you can
also decide whether opened panels which do not belong to these events should
be closed or not.
Panel Control in CANoe
With Panel Control under the main menu item Panel you can arrange and position
any panel group you want and save them under a defined name.
In this dialog Panel Control you can also open and close the defined panel
groups and single panels.
Note, that only one panel group and/or any single panel can be opened at a
time.
2.6.5 Configuring the Panel Control for Small Models
When small models are set up, it is often unnecessary to implement the mechanisms
of panel control. Here it is advisable to first enter all necessary panels into the list of
permanently opened panels. You should always use the list of panels to be opened
after the start of measurement if there are certain panels which you only wish to use
during the measurement. You can decide in the configuration dialog whether these
panels should automatically be closed again at the end of a measurement.
2.7 Logging and Evaluation of Measurement Files
CANoe offers you the option of saving the CAN data traffic in a log file, so that you
can evaluate it later in Offline mode.
Logging blocks are provided to you for this purpose. The task of a logging block is to
store data arriving at its input to a file. You can configure the log file in the measurement
setup by the file icon at the far right in the logging branch.
Each logging block is equipped with user-friendly triggering to reduce the amount of
data as much as possible even before acquisition. This permits the formulation of a
trigger condition, and data are only saved near the time of the trigger. During each
measurement multiple triggers can be initiated for various events, whereby the user
can prescribe pre-trigger and post-trigger times. The trigger condition is userprogrammable.
You can configure triggering in the measurement setup via the
Logging function block.
CANoe has an Offline mode for analyzing log files. In contrast to Online mode the
data source here is a file, e.g. a file created by logging in Online mode. All measure-
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
59