CANoe DENoe - KEMT FEI TUKE

Message was not transmitted (14)
The last transmit request was not executed by the CAN controller. This may be
due to the error status of the controller, or due to the accumulation of too many
higher priority messages.
DLC error (1128, 111, 112)
With the CANIB card a smaller DLC is specified in the DPRAM setup than
should be transmitted. This size must be adjusted in the CAPL generator block
or replay block.
This error can trigger other consequential errors. When problems are encountered
the computer should be rebooted with a cold start!
Due to a firmware error in CANIB, a DLC equal to 0 cannot be processed.
Therefore, it is set to at least 1 in the driver. However, an adjustment for calculating
the size of the available DPRAM will not be implemented until Version 2.0.
DPRAM Overflow (5) DPRAM
In the message setup more messages are defined than the DPRAM can receive.
Due to the fact that CANoe checks the number of messages, this report
doesn't appear.
Incorrect controller no. (3,10,113)
An attempt was made to access a nonexistent CAN controller. Most CAN cards
supported by CANoe have two controllers. But there are also cards with just
one controller.
Remedy: Look for a message CANn... in the CAPL programs, where n is
greater than the number of existing controllers. This must be replaced by a correct
number.
Incorrect module number (109)
No CANIB was found at the address given. If the port address has been
jumpered over on the card, this must be communicated to CANoe See the
manual.
Incorrect checksum (1368)
The CAN controller detected a faulty CRC checksum.
Incorrect terminating code (1432)
For CANIB cards this is the error code for general firmware problems. These
occur primarily in BUSOFF and ERROR_PASSIVE states.
Incorrect card type (8)
CANoe card driver and hardware are not compatible.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
75