CANoe DENoe - KEMT FEI TUKE

Figure 55: Simulation Dialog
Note: If you are operating CANoe in simulation mode, i.e. without a physical bus,
the program emulates the functionality of the CAN chip on the interface
card. In this mode, the bus baud rate is the only system parameter you
would only configure in the card's configuration dialog. In this case, the
values of the other card parameters do not have any effect on program
execution. For small animation factors, a high baud rate might result in the
time resolution of the chip emulator being insufficient. You would then get
an error message, in which CANoe would inform you of the smallest feasible
animation factor. To be able to continue to run a simulation in real time
(Animation factor 1) you could reduce the baud rate in the card's configuration
dialog. However, this will change other system properties such as
the latency times of certain messages under high bus loading.
If you are operating CANoe without a card please observe the instructions in the Appendix.
3.3 Trace Window
All messages arriving at the input of the Trace block are displayed as text lines in the
Trace window.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
93