CANoe DENoe - KEMT FEI TUKE

42
are interpreted as gateway definitions. To meet this rule, there must be a CAPL
block in the simulation setup that has to be assigned to a database node and
has to be included as a gateway.
It does not meet this rule, when a CAPL block is included as a node in one of
the buses while no database is assigned to this bus.
• 3rd Rule: All gateways that are defined in the databases must be included
as gateways in the assigned buses within the simulation setup.
Example:
This rule is slightly different to the 2nd rule. It does not meet to include a gateway
– that is defined in the databases – in the available buses of the simulation
setup. The concerned CAPL block must be included as a gateway in the buses
to which the databases are assigned to.
2.2 Measurement/Measurement Setup
2.2.1 Measurement Start
The measurement is started by pressing the F9 key, by choosing Start│Start in the
main menu or by activating the start button on the toolbar. In Online mode data
can now be received and evaluated from the bus or can be sent out onto the bus.
The data flow diagram shows you which analysis and transmit blocks are active during
the particular measurement.
At the start of an Online measurement, first the CAN board is initialized. If this cannot
be done, an error message is output and the measurement is terminated.
During the measurement the user can configure the Trace block, Data block and the
scaling of the Statistics window and Data window. However, the menu items in the
popup menus of the remaining blocks are masked out for the duration of a measurement.
You cannot parameterize these blocks until after the measurement run has
ended. All keyboard inputs during the measurement are passed through directly to
the function blocks (CAPL programs, generator block, etc.). They are shown in the
relevant status window on the toolbar. The only available program controls are the
key (terminate measurement) and all of the key combinations with the
key (Window control under Windows).
You can stop the measurement by pressing the key, selecting the main menu
item Start│Stop or activating the button on the toolbar.
Internally, the measurement can be terminated by the elapse of the post-trigger time
after triggering has occurred, or by the call of the stop() function from a CAPL program.
Note: During high system loading the stopping process may take a certain
amount of time, since the system's message buffer must be emptied. A repeated
stop command (double click) causes the buffered data to be ignored,
and the measurement is terminated immediately, even under high
system loading.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1