CANoe DENoe - KEMT FEI TUKE

112
Figure 64: Data Window Configuration
All signals of the signal list are shown in the list box at the upper left of the dialog.
Here you can accept new signals from the associated database. When copying, the
abbreviated signal name is modified such that no ambiguities result. The abbreviated
name appears during the measurement as the signal identifier in addition to the actual
signal value.
With the [Define] and [Edit] buttons you can enter a new signal description - independent
of the database - in the Data window or modify an existing signal description.
3.6.2 Display Types
Signal values can be displayed in the Data window in the modes shown below. The
output width of the signal value is automatically calculated from the bit length and
conversion formula. CANoe takes the necessary signal data from the database:
Physical
The raw data are extracted from the CAN message, scaled by the (linear) conversion
formula, and displayed as decimal fixed point numbers.
Example: Signal T consists of 5 bits, is unsigned, has a factor of 10 and an offset
of 0. Then the possible raw value range is 0-31, and the physical value
range is 0-310. Therefore, the necessary output width is 3 characters.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1