CANoe DENoe - KEMT FEI TUKE

Figure 71: Generator block Configuration of Transmit list
123
When one of the trigger conditions occurs, the next element of this list is transmitted.
When the end of the list is reached the program resumes with the first element if the
run mode has been set to cyclic. The list may also consist of only one element.
Nine lines are displayed in the dialog box. The active line - to which the dialog buttons
refer - is identified by the " " symbol at the beginning of the line. The active line
is shifted automatically by activating the key or by clicking the dialog entry
boxes with the mouse.
Each line of the list consists of 11 columns. In the first column you enter the desired
identifier. The DLC field defines the number of data bytes in the message. After that
come the fields for data bytes. Only the number of bytes specified by the DLC are
accepted. The rest are ignored. The last column is a combination box for selecting
the controller by which the message is to be transmitted.
4.1.3 Entry of Signal Values
You can configure the generator block symbolically, provided that you are working
with a database. Use the option button [Symbol...] to select a message from the database
which is to be transmitted from the generator block.
Then the physical signal values of the message can be defined with the [Signal...]
button.
Displayed in the signal value input dialog are the individual signals of the message
that was on the active line of the transmit list. If the message only contains standard
signals, the signal list consists of three columns. The individual signals are listed in
the lines. In the last column you can prescribe a signal value. If you have assigned a
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1