CANoe DENoe - KEMT FEI TUKE

Figure 72: Signal Response Generator
125
The configuration dialog allows you to parameterize a trapezoidal function. When the
dialog is exited with OK the corresponding lines are automatically generated in the
generator block transmit list. The following signal responses can be generated with
certain parameters:
Signal response Parameter
Square ta = tf = 0
Triangular th = tv = 0
Saw-tooth th = tf = tv = 0 or
ta = th = tv = 0
Constant n1 = n2
Displayed in the upper part of the dialog box are the message and the signal. Shown
below this, in the preview box, are a trapezoid and the meanings of its parameters.
By setting individual parameters to zero, the following responses can be generated:
The levels n1 and n2 must be entered physically. The relevant limitations apply here
(see for example generator block signal values).
The entry for transmit interval identifies the interval between any two messages, and
this corresponds to the entry in the generator block dialog Trigger initiation period.
Since CAN is message-based and not signal-based, all signals of a message get the
same transmit interval!
Since this signal characteristic generator is only a tool for the generator block and is
not a block itself, the following must be observed when using different period lengths
for several signals within one message:
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1