CANoe DENoe - KEMT FEI TUKE

5.9 Panel Control
153
For complex CANoe models with many input and display panels it is often impossible
to arrange them all simultaneously on the screen. On the one hand, the screen does
not provide enough space. On the other hand, system resources are inadequate to
simultaneously open an arbitrary number of panels.
However, usually only a small subset of all panels is needed a any given time for
measurements and simulation runs. Panel control for CANoe therefore provides you
with the option of grouping panels according to your work requirements.
With different panel control buttons you can select, which panel should be opened
or closed during the measurement.
Each panel control button is configured with a list of the panels which are opened
when the button is activated. Then during a measurement you can open specific
panel groups from the control panel simply by pressing the appropriate panel control
button.
In the panel control configuration dialog, under Text you enter the text you wish to
label the button with. Under Font Size you can enter the size of the text characters.
In the list below this you now enter the panels to be opened when the button is activated.
All panels not entered in the list are closed automatically if you activate the
check box Close Other Panels.
Note: In CANoe you can define permanent panels which are unaffected by panel
control actions, i.e. they remain open even after a panel control button is
activated, if they are not listed in the control list of the button.
With the [Add] button you can add new panels to the panel control list. Pressing
[Delete] removes all marked panels from the list. Press [Display] to open the panels
marked in the list for viewing.
Note: Since you may wish to use the same panel in various CANoe configurations,
the panel positions are managed directly by CANoe. Therefore, they
cannot be set in the Panel Editor.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1