CANoe DENoe - KEMT FEI TUKE
CANoe DENoe - KEMT FEI TUKE
CANoe DENoe - KEMT FEI TUKE
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
74<br />
Card cannot be initialized<br />
Timeout ...<br />
With error messages of this type, <strong>CANoe</strong> cannot establish a connection to the<br />
CAN hardware. Check the installation of the CAN card. Please compare the instructions<br />
in the installation guide of your hardware.<br />
Above all, notebook PCs frequently use a power manager. This must be deactivated!<br />
(please compare the instructions in the installation guide of your hardware).<br />
Error message: "Error in transmission"<br />
Immediate state change of CAN controller to ERROR PASSIVE<br />
• Bus not connected?<br />
The bus connection should be checked, and possibly also the pinout of the<br />
connector being used.<br />
• Terminating resistor present?<br />
In particular, the CAN AC2 version with 82527 controllers reacts sensitively to a<br />
missing bus termination.<br />
• No partner on the bus?<br />
If the bus is only connected to one of the two CAN controllers, and there are no<br />
other bus nodes, the controller does not receive any acknowledge for transmission<br />
attempts.<br />
• Baud rate and output control set?<br />
The controller register can be programmed by the popup menu of the CAN-card<br />
icon. See section 2.11 for a more detailed explanation.<br />
Error message:<br />
An error has occurred in ...<br />
For further information please report the<br />
LINE and FILE to our Hotline<br />
At the current level of technology it is impossible to develop completely errorfree<br />
programs that are non-trivial. Unfortunately, this is also true of <strong>CANoe</strong>. To<br />
better localize and correct system errors that occur very seldom, <strong>CANoe</strong> has diagnostic<br />
mechanisms that report these errors. Please be sure to write down the<br />
exact text of the error message. With this information our telephone Customer<br />
Support can then help you to correct the problem more quickly.<br />
2.10 List of Error Messages to the CAN Interface<br />
Error messages related to communication between <strong>CANoe</strong> and the CAN PC-card as<br />
well as errors on the CAN bus or in the CAN card firmware appear in this list. In each<br />
case, a clear text and an assigned error number are given. Some of these messages<br />
are hardware-specific and therefore do not occur with all card types.<br />
© Vector Informatik GmbH <strong>CANoe</strong>/<strong>DENoe</strong> Manual Version 4.1.1