CANoe DENoe - KEMT FEI TUKE

107
10x , n = [1 to 9], x = whole number). The lower and upper range limits are
rounded-off to the precision of the Division value.
Rounding always affects all signals of the Graphics window. The active mode
(X-mode, Y-mode or XY-mode) is considered. Scaling of the signals is roundedoff
to a whole number value.
Get scalings/Store scalings
Marker
Grid
Y-Axis
You can save the scaling configuration of the Graphics window (i.e. the time
range displayed for all signals and the value ranges of each individual signal) as
a home configuration. The default home configuration has a time range from 0
to 5 seconds and the Min/Max value range of each signal taken from the database.
With the function Store scalings the current scaling of the active Graphics window
is saved. In doing so, the active modes are considered (X-mode, Y-mode
or XY-mode, and Single-Signal or Multisignal mode). Afterwards, you can reset
all scalings in the Graphics window to this stored configuration at any time with
the function Get Scalings.
This command activates or deactivates measurement point marking. The color
of the measurement points matches the preset signal color.
This command enables/disables grid lines in the Graphics window. The grid
lines match the subdivisions of the Y-axis. You can set the color of the grid lines
in the Color Options dialog.
This command enables/disables labeling of the Y-axis in the active Graphics
window.
When labeling is disabled, a Y-axis with 10 subdivisions is displayed for all signals.
In the legend the following are shown for each signal: Lower and upper
values of the viewing area, and the value amount between any two subdivision
tick marks.
If labeling is enabled, the subdivision of the Y-axis is calculated automatically for
the active signal and is displayed in the color of the signal.
The tick marks are set to whole number values. If a signal is shown as decimal
(i.e. raw signal values without conversion), then only whole numbers are displayed.
In this case, if an area between two adjacent numbers is shown magnified,
no subdivision tick marks will be seen any longer along the Y-axis. For the
physical display type subdivisions less than 1 are also shown.
When labeling is enabled the legend also shows the following for each signal:
Lower and upper values of the viewing area (i.e. not necessarily the values of
the lowermost and uppermost Y-axis tick marks) and the value amount between
any two tick marks.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1