CANoe DENoe - KEMT FEI TUKE

The popup menu command Copy contents to Clipboard accepts the contents of the
Write window in the clipboard. Write window messages serve as both a supplemental
report for your measurements and – should problems occur – as a basis for error
analysis by our customer service.
You can find a description of the most important CANoe system messages that are
output to the Write window in the online help.
3.6 The Data Window
Data windows serve to display signal values. Signals are understood to be data segments
of a message which carry specific information (e.g. engine RPM for CAN
buses in motor vehicles). In the Data window you can view signals in a user-friendly
manner. When a symbolic database is used the values of the signals specified there
can even be displayed as physical variables. For example, engine RPM can be
viewed in revolutions per minute, or temperature in degrees Celsius.
Figure 63: Data Window
Always displayed are the signal name - which can be set in the configuration dialog -
and its associated value. You can also decide whether the value should be displayed
as a raw datum (hexadecimal or decimal), as a physical value with accompanying
unit of measurement, or as a bar chart.
The signal names and values displayed in the window are context-sensitive. When
the mouse pointer is moved over them, the element below the pointer is identified by
a frame. This element can be dragged to any window location with the mouse, allowing
you to group signals and values according to your needs.
3.6.1 Configuration of Signals
From the popup menu of any data block or window, a configuration dialog can be
opened in which you can enter the signals that should be displayed in the particular
window, add or delete signals, or set their representation parameters.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
111