CANoe DENoe - KEMT FEI TUKE

76
Remedy: The correct CANoe version should be started, or another CAN card
should be installed.
Error in statistics request ()
The CAN card or its firmware does not support bus statistics.
Faulty ID, DLC etc. (1544)
Can neither appear at the CANalyzer Window nor at CANoe.
Exception: CANIB. Description see 1128
FIFO entry>16 (114)
CANIB has reported invalid data to CANoe. A potential cause for this is a RX
buffer overrun. This cannot be detected directly if the CANIB was not initialized
correctly. If its jumpers are transposed the user should follow the instructions in
the CANoe manual.
Interrupt not found (108,2016)
Proper communication could not be established with the CANIB card. A check
should be made to determine which interrupt is jumpered on the CANIB card,
and whether there could be collisions with other hardware. It is often the case
that there is an overlap conflict with the mouse interrupt. The CANIB driver itself
can determine the interrupt allocated to CANIB. If this is unsuccessful the IRQ
number can be entered explicitly starting with Version 2.0 (see
BOARDCFG.INI).
No final code received (1384)
Can neither appears at CANalyzer nor at CANoe.
No access to IMP (12)
The firmware hasn't received access to the interface management processor of
the Full CAN Chips 82526.
No reply from CAN controller (106)
The firmware could not establish a connection to the CAN controller. This is an
indication of a defective CAN card.
No messages in RX buffer (1)
No message received (7)
No data are currently being received by the card.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1