CANoe DENoe - KEMT FEI TUKE

102
3.4.2 Arrangement of Signals
To exclude certain configured signals from the next measurement, you can deactivate
them before the measurement. To do this, select the desired signal from the legend.
Then in its popup menu choose the function Deactivate. You can also reactivate any
deactivated signal from the same place.
Moreover, you can also change the sequence of signal entries in the legend of the
Graphics window. This is useful if you have configured a rather large number of signals,
but the window is too small to show them all in the legend. Additionally, you can
move the deactivated signals to the lower border so that you can still see as many of
the active signals in the legend as possible, even with relatively small window dimensions.
To move a signal entry you would select it with the mouse and choose the desired
direction from the popup menu or by the key combination or
.
3.4.3 Signal Layout
The signal layout for signals shown in the Graphics window can be controlled by a
number of functions. You can set basic options in the Graphics Window Options
dialog, which is opened from the window's popup menu or by double clicking the window
with the right mouse button. All functions used to arrange the signals in the window
or to study them after the end of the measurement are opened from the Graphics
window's popup menu or the toolbar and are described in the next section.
Figure 61: Configuring the axes in the Graphics window
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1