CANoe DENoe - KEMT FEI TUKE

In the Entire Measurement trigger mode the entire measurement is logged. Pretrigger
and post-trigger times cannot be selected. Activating the button Write full
buffer to file causes a full data buffer to be saved intermediately for long measurements.
You can avoid data loss in this manner.
Trigger
Pretrig. Post-Trig.
Log file
Pretrig. Trigger n Trigger n+1 Post-Trig.
Log file
Time axis
Time axis
Figure 44: Time Window for the Trigger in Single Trigger Mode (top) and in Toggle-
Trigger Mode (Bottom)
In the Single Trigger trigger mode all those data occurring before and after a specific
trigger is logged. You can enter the necessary settings for pretrigger and post-trigger
times, and the number of triggers you wish to log, in the Time section.
In Toggle Trigger trigger mode the time window is described by two successive triggers
(start-of-block and end-of-block triggers). The first trigger activated during
measurement is the start-of-block trigger, and the second is the end-of-block trigger.
Afterwards, another start-of-block trigger follows, etc. The pre-trigger time in toggle
trigger mode is referenced to the start-of-block trigger, and the post-trigger time is
referenced to the end-of-block trigger. With the check box Use combined toggle
mode you define, that for start-of-block and end-of-block trigger the same trigger
conditions are valid.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
61