CANoe DENoe - KEMT FEI TUKE

126
The generator creates a list of messages with:
No. of messages = Period / Transmit spacing
This is exactly one period. If the transmit list contains more they are rejected. Using
the combination box Remainder of the user can define how remaining signals are to
be handled for supplementally generated messages:
• All bytes to 0:
All signals are set to the raw value 0.
• Continue cyclically:
During generation the previous messages are copied as often as necessary until
the new period length is reached.
Example:
The original list contains 3 messages, and the new period length requires 9
messages. The new signal (byte 1) is a saw tooth.
Original Transmit List: New Transmit List:
0 0 0 4 0 1 0 0 4 0
0 1 0 2 0 2 1 0 2 0
0 2 0 4 0 3 2 0 4 0
4 0 0 4 0
5 1 0 2 0
6 2 0 4 0
7 0 0 4 0
8 1 0 2 0
9 2 0 4 0
The recommended procedure for generating multiple signals is therefore as follows:
The signals are defined beginning with the shortest period length. Then only integer
multiples of this period length are used.
4.2 Interactive Generator Block (IG)
The purpose of the interactive generator block is to generate and transmit messages.
Messages can also be configured and interactively transmitted during a measurement
(Online). This makes the interactive generator block especially well suited for
influencing a measurement in a quick and improvised way. In many cases, with the
interactive generator block you can achieve your goal without the use of traditional
generator blocks and without CAPL blocks.
Interactive generator blocks appear in the data flow plan of the measurement setup
as small blocks with the label IG. Just like traditional generator blocks they are permeable
to all data in the data flow diagram. That is, they do not filter the data flow like
filter blocks or CAPL blocks do, rather they act in a purely additive manner.
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1