CANoe DENoe - KEMT FEI TUKE

Command from driver not supported (6,11,1528)
CANoe has sent a command to the card driver which it or the firmware does not
recognize. Example: A bus statistics request to a card without the appropriate
logic.
RX buffer overrun (101)
The receive buffer could not accept any more received messages.
There are several methods for remedying this situation:
• Insert breaks in branches of the data flow plan which are not needed. In an extreme
case the statistics block, data block and trace block can be disconnected
by breaks. The measurement is recorded with the logging block and afterwards
is evaluated offline.
• For Basic-CAN controllers a reduction in the data stream can be achieved by
acceptance filtering. Except in special applications the second controller in particular
may be completely disconnected by this method.
• For Full-CAN controllers data reduction can be accomplished by striking messages
in the message setup in conjunction with filter blocks.
• Switching-off the statistics report or other unnecessary options.
RX register overrun (105)
The Basic-CAN 82C200 controller has only two internal registers for accepting
messages. At higher bus frequencies and higher message rates, newly arriving
messages overwrite this buffer before the firmware can read out the register.
Correction: Use acceptance filtering.
Timeout (1080)
Timeout while accessing card (4,232)
Communication problems with the firmware occur during a measurement.
Remedy: Terminate measurement and restart. If this does not help, the reset
button can be pressed for some cards. Otherwise, the PC should be rebooted.
Timeout during card initialization (0)
No reply from the card (1400)
No connection could be established with the firmware when the CAN card was
initialized.
TX buffer full, TX-REQUEST rejected (2)
The transmit buffer is still full. The new transmit request cannot be processed.
There are three possible reasons for this:
© Vector Informatik GmbH CANoe/DENoe Manual Version 4.1.1
77