Introduction to the Agilent 7100 Capillary Electrophoresis System

Maintenance 8
Cleaning the Electrodes, Pre-punchers and Insulation Plate
Accessing the Electrodes
1 Use a screwdriver to unscrew the two metal screws holding the insulation
plate.
2 Use a screwdriver to remove the screw that secures the blue ground cable.
Metal screws
Insulation plate
Figure 58
Insulation plate
3 Use the 12 mm hexagonal socket screwdriver to unscrew the inlet electrode.
12 mm hexagonal
socket screwdriver
High voltage cable, red
Ground cable screw
Ground cable, blue
Figure 59
Removing the ground cable and the inlet electrode cable
Agilent 7100 Capillary Electrophoresis System User Manual 199