Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1If the Timecode selected to locate to is beyond the last item in the EventList then a dialogue box will appear to indicate that no item can belocated.To change the Selection of Events displayed> Click on the drop down arrow next to the Event Type in the Filter box.> Click on the required Event Type in the list, or> Click on All to see all Event Types.> To view more than one event Type in the List, click Set Custom Filterin the Events box.The Event Filter Selection dialogue box will appear.> Click on the check boxes to set the required selection of Event Types,then click OK to return to the Event List dialogue box.To change the Paths listed> Click the Selection radio button in the Paths box.> Click the required paths in the Path list (click the Clear button to resetthe selection and start again).To Add to the Event List> Click the Add button, and the Add New Event dialogue box willappear.> Click the required path(s) in the Paths list (up to 20 paths can beselected).> Click the drop down arrow for Process and select the required process.> Click the drop down arrow for Control and select the required Control.> Click the up/down buttons next to the Value box to change the Value.> Either:• Change the Timecode manually,• Click in the Label List to set an existing time, or• Press A to F to use a Preset.Timecode zero may not be used as this is reserved for Initial Snapshotvalues.> Click on Add to insert the event and return to the Event List box.> When Events have been added / deleted, a new Mix/Pass will be createdand added to the Mix/Pass Tree on clicking Exit on the Event List dialoguebox.(You can abort these changes by pressing Cancel).- 103 -