Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Map ChannelThe Channel Mapping Tool is a screen that is used to copy snapshotsettings between Channels.> Click the left/right arrows at the top of the screen to scroll theChannels.> Click on the required source Channel.It will be outlined in red and this is where the settings will be copied from(this is the same as pressing SOLO on the Channel module).> Click Map Channel in the Operations Menu, and the ChannelMapping Tool will be displayed.> Click and hold on the blank grey area at the bottom of the outlinedChannel (the pointer will change to a box containing the word All).> Drag the pointer to the required target Channel.If the target Channel is not shown, drag the pointer to the border of thedisplay in the required direction.When the pointer is held over the border, the Channels will scrollsideways.> Move the pointer away from the border when the required Channelappears.> Release the button, and a confirmation dialogue box will be displayed.> Click OK.To copy the settings of a section from one Channel to another> Click the left/right arrows at the top of the screen to scroll theChannels.> Click on the required source Channel. It will be outlined in red and thisis where the settings will be copied from (this is the same as pressingSolo on the Channel module).> Click and hold on the required section within the outlined Channel. Thepointer will change to a floating copy of the selected section.> Drag the pointer to the required target Channel.> If the target Channel is not shown, drag the pointer to the border of thedisplay in the required direction. When the pointer is held over the border,the Channels will scroll sideways. Move the pointer away from the borderwhen the required Channel appears.> Release the button.A confirmation dialogue box will be displayed.> Click OK.> When all the required copy operations are complete, click OK, and theChannel Mapping Tool will close.- 130 -