Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Extended Prefs (Libra Live only)Led On When CutWhen checked, the status LED above the channel Mute key will beilluminated when the signal is cut by the key.Normally used when switches engraved CUT are fitted to the fader strips.If the option is un-checked then the status LED above the mute key will beilluminated when the signal is on (i.e. not cut).Normally used when switches engraved ON are fitted to the fader strips.Fader Input MeteringThe fader strips are fitted with a mini bargraph meter.These are normally used to show gain reduction caused by Dynamicselements in the signal path.If this option is checked then the meter will show the level of the input tothe path.If it is not checked, it will show any Compressor & Gate processing.Upper Knob LockWhen this option is checked then the surface Lock Knob key is enabled forfreezing the operation of the Assignable Logicator.When unchecked, the Lock key will lock both the fader path and theassignable logicator function against changes.Aux LED On when CUTWhen selected, the aux switch illuminates when the Aux is cut. (Thisoption is for people who feel the Aux send switch should be consistentwith the channel On/Cut switch).Snapshot Touch ScopeNo longer implemented.Channel Strip New LayoutIf ticked, will show the display of controls on Channel Strip Panels (MMC /88D) in an alternative layout.Aux Cut IdentThis option is no longer implemented.Alternative Aux LayoutUses an alternative layout for placing Auxiliary controls on Channel StripPanels.This option only applies to Live, MMC and 88D consoles.- 79 -