Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Instant Chase On Add Machine To GroupThis causes machines to immediately position themselves to the GroupMaster position when added to a group.Auto Stop Updates AutomationThis is used when Stop is pressed twice to issue an All Stop command.The automation system will then locate to the time at which All Stop wasissued and the desk will be updated with the control settings at that point.This is typically used when rewinding or fast forwarding and it is necessaryto see the state of the Play Pass at the point where All Stop is pressed.Automatically Restore Last Groups When Encore StartsLoads the last used group setup when Encore opens.PresetsWith the exception of the Rollback time, all of the following options needto be ticked to enable them.Pre Roll TimeThis is a timecode value that sets the amount of extra timecode that atape is re-wound by when executing a Locate or Cycle.> Tick to enable.Post Roll TimeThis is a timecode value that sets the amount of extra time that a tape willcontinue for at the end of a Cycle before rewinding to go back to the CycleStart time.> Tick to enable.Rewind LimitThis is the lowest timecode (or foot-frame) position that machines will goto when rewinding before they stop automatically.> Tick to enable.Fast Forward LimitThis is the highest timecode (or foot-frame) position that machines will goto when fast-forwarding before they stop automatically.This is useful when using older reel-to-reel tape machines to preventunspooling.> Tick to enable.Roll Back TimeThis is a timecode value that sets the amount of re-wind when a Roll Backcommand is sent to the transport device(s).- 74 -