Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Stem / 2T Fader Mapping (Analogue)The Fader Allocation screen allows you to map any of the large or smallfaders to control stem inputs and outputs, 2T mixers and the Music,Effects and Dialogue faders (plus the Utility fader, where fitted).On consoles larger than 96 channel strips, it is only possible for the first96 faders to be mapped.> In the Fader Resource section of the screen, either:• Click on the 1-12, 13-24 etc buttons (to display the appropriatebucket of faders underneath). Click LF to select Large Faders, SF forSmall Faders, then click on any of the 12 fader numbers underneathyou wish to map, or,• Click the numbered Group Output you wish to map, or,• Click M, D or E (or U where fitted).In all cases, the button will turn green.> Next, click on the box to the right of the path you wish to control in thelower half of the screen.The fader selected will be displayed next to the relevant path. (Click in thesame box again to clear the mapping for that control).> Repeat for as many controls as you wish to map.> Alternatively, after selecting the fader to map, click the ALL button inthe relevant section and all of the available paths will be controlled by thatfader.In this way for example, a single fader can control all of the Stem Inputs.The fader mapping is stored as part of any Recall files that are taken, butis not stored as part of the Desk Setup that is available for reloading afterrebooting the console.> Click on CLEAR to reset all of the fader mapping.The Fader Allocation screen does not need to be open or minimised for themapping to remain in place.It will remain until either CLEAR is clicked or a Recall file is loaded tooverwrite it.AES Config (Digital)On bootup, the desk will reload the last used Setup file, and display it'sname in the title bar.When the AES960 racks are placed under console control AES I/O pairs 28are used to pass control data to and from the console and as such are notavailable audio channels (so you lose X madi 55 & 56, where X = themadi port number ).• The individual W/Len, Mute & State windows are active with themouse cursor over that window. Its parameter can be changed by useof the left or right mouse buttons.• In the case of W/Len the options are 24, 20dt or 16dt, with the last2 options having triangular dither applied.• The Mute can either be On or Off.• For State Input the options are BYPass, SRC or AUTO; for StateOutput the options are BYPass, INT44, INT48, INT88, INT96 orBlok (A...G).In addition for the INTxx options pressing and holding down the mousebutton toggles the Pull-Down flag on/off.- 132 -