Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1There is a Global Parameter selection area, which selects Master Syncand Misc Options.A selector box to select each rack in turn and a Copy To All tick box areplaced immediately underneath.The Copy To All option, if enabled, will change all the parameters insimilar boxes.This is useful for initial setup, but can equally lose a carefully arrangedconfiguration, if this option is ticked a big warning message appearsbefore any change is made.The Refresh button is a useful diagnostic tool as it collects and displaysthe status of the currently selected rack, this is carried out on opening thepage, selecting a different rack and on pressing the Refresh key.This task will take a few seconds to load.The Save and Load keys on the front panel allow the saving and loadingof up to 4 presets and in addition the current settings are associated withthe console's Mix Setup.Inputs• Pair: the inputs as a stereo pair• Name: XXXX• State: either BYP, AUT or SRC• Mute: either M or (blank)• Status: NIThe State of the input will either say:• SRC (where the input signal is converted to a desired sample rate)• AUT (where the incoming signal is automatically converted to therequired sample rate), or• BYP (where the incoming signal bypasses the conversion route).Channels can be muted by clicking next to the required input in the Mutecolumn. When a signal is muted, it will show M in the column.The Status column indicates the condition of that input. If NI is seen inthe column, then there is No Input.OutputsPair: the inputs as stereo pairName: XXXXState: either 96, 88, 48, 44, BYP, or Blk(X) [where X = block number,A - F]Mute: either M or (blank)W/Len: either 16dt, 20dt or 24Where there is more than output that needs to be universally converted,cycle through the options in the State column.It divides the SRC into blocks, where it is possible to set the SRC for ablock of outputs rather than having to apply the same SRC to each outputindividually.- 133 -