Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1PyramixBoth Encore and Pyramix need to be either on the same network orconnected via discreet cabling, and they must both have the same IPaddress.This is set from within Pyramix in Settings / General Settings /Controller / Add an IP address.Give it a name, and when prompted for the driver, select Driver-OASIS.The IP address in Windows is set within Control Panel / Network /Internet Protocol / General / TCP/IP, although you may not need toaccess this.> Run the program called PyriPyri.exe located in C:/Encore (this alsogives the Windows IP address.> The Console box must be ticked, and the port should be set to 2000.The text will show whether there are valid communication betweenPyramix and the console.> To set up Pyramix, go to Open Project.> After a Save+Load, Pyramix must be re-synched again, using theGeneral Settings page in Pyramix, then hitting Apply Changes.NB:In Pyramix / General Settings, if there are other controllers availableand configured, they must all be disabled apart from the Encore IP asthis will cause conflict.Pyramix will map Input 1 to Input 1; Input 2 to Input 2 etc. It is a straight1:1 ratio and is not supported for all other path types.The currently supported controls are Faders, Pans and Cuts.- 118 -