Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Park Window(frames)Allowed error after a locate or chase operation.This is the maximum allowed difference between the position required bythe locate or chase operation and the actual final machine position.If the difference exceeds this value, than another locate will be performed.Edit Delay(frames)Number of frames the machine takes to respond to an Edit On command.This setting should be used to compensate for the time required by themachine to perform an edit on (i.e. enter record) after receiving thecommand.The compensation is applied during programmed external recording.EE Delay(frames)Number of frames the machine takes to respond to an E to E (inputmonitor) command.This parameter is similar to the previous value but applies to the responsetime to an E to E command.Min Cue SpeedSmallest permitted value of shuttle speed command.Units - 1/64th of play speed, i.e. 4 = 1/16th , 128 = 2*play speed.This value should be used to set the minimum shuttle speed for themachine. Higher values will result in the machine moving in response toshuttle wheel movements below the normal minimum shuttle speed.Max Cue SpeedLargest permitted value of shuttle speed command.Units = multiples of play speed.This value should be used to set the maximum shuttle speed.Larger values will result in higher shuttling.This parameter can be used to slow down machine shuttling if desired.Stop Count(frames)Machine must be motionless for this number of frames before a Stop isreported.Increasing this value will force the MCS to wait for the specified number ofmotionless frames before considering the machine to be stopped.Poll Timing- 95 -