Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Error above this value will cause the machine to go into shuttle moderather than servo mode.Lock Correction(frames)Number of frames a machine will ‘jump’ when releasing.The parameter allows correction for machines who’s reported position“jumps” when it is released from servoing. Adjustment of this parameteris normally not necessary.No Lock WaitNon zero means assume lock when zero error is achieved before machinereports servo lock.Setting this to a non-zero value will decrease machine lock up time insome cases (for example 7030).This is because certain machines may achieve and hold zero error forsome time before actually reporting lock.Servo Hold(frames)Hold servoing for this number of frames before issuing play.Once zero error has been achieved, the MCS will continue to servo at playspeed for the time specified.This can help avoid situations where the machine is servoed up frombehind and is possibly speeding up when released and therefore could beinto the next frame when released.Release Hold Off(frames)Number of frames to wait after releasing before Lock is confirmed.This parameter controls the last stage of the servo process for a machine.After zero error is achieved and the machine is released, the MCS will waitfor the specified time before lock is confirmed.This gives more leeway for final errors to be corrected if required.Adjusting this value may help if lock errors are observed after lock hasbeen reported.Shuttle StopNon-zero means that machine will be slowed down to stop. The larger thenumber the gentler the action of the stop command.Unlace Time(seconds)Distance to target in locate/chase above which unlaced or high-speedwind will be engaged.- 93 -