Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1In Extended Mode CollectTouch:• The ALL/SCOPE & TO ENDfunction (where a static valuecan be written to thebeginning and the end of thetimeline) is blocked out.• The TO END function stillworks as usual.• Safety Nets are respected, soif the TO END button ispressed outside and beforethe Safety Net In time, thatstatic value will be written tothe end of the Safety Nets.• Buffer A & B still work as theydo in Standard Collect Touchmode.> Clicking the Label button. The Label List will open allowing you to selecta labelled time, or> Click Grab Time. This can either be clicked when the timecode isrunning or stopped. The current time will be placed into here.You can still edit the time after selecting it by any of the above methods.At The Last Stop TimeThe Master Touch state will go from Isolate into Record when the timelinepasses the last STOP point.This ensures continuity of automation while preserving all previous data.Always In WriteMeans that all controls within the scope of Collect Touch will be in Write atall times.Brightness Controls (digital systems only)The Brightness Controls page is used to set the illumination levels forLEDs, buttons and alpha displays on the console surface.All of these control sliders should be set at about 75% as shown left.Pan & Operating LevelsThe Pan & Operating Levels page is used to set the indication response offaders and Logicators and the overall operating level for the console.Fader IndicationThe alpha display just above the fader can be set to:• Always display the path name,• Always display the fader level, or• To display the fader level only when the fader is touched, otherwisethe pathname is displayed.Page Two Toggle ModeNot currently implemented.Pan Logicator ArcThe sweep of the Logicators can be set to 180° or 270° for when they areused for panning.- 66 -