Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1When Recall finds a control that does not match the currently loadedStore, the scan will stop and Recall will display the section(s) and thecontrols which do not match. The Channel Solo key will also illuminate.For example, on the left is shown the Monitor Section.> Adjust each control so that it matches the setting in the Recall Store.> As you alter each control, the large expanded graphic on the top rightside of the screen will change so you can match up the control to the redline indicating the controls position.This large graphic will chase to whichever control is being altered.For Faders and Mutes, their adjacent automation mode led will display ifthe control needs resetting manually:• For Mutes, the led will flash if the state needs to be changed (oncethe state has been toggled the led will extinguish).• For Faders, the null leds will indicate which direction the fader needsto be moved to match the Recall store.When the fader is within 3dB of where it should be, the led will start theflash.Once it has reached the correct position, the led will extinguish, and aseach control is matched it will be removed from the display.When all controls in a section are reset, the section will be replaced bytext indicating the section is reset.When all controls on a Channel module or the Monitor section have beenreset, Recall will continue scanning.Auto Recall scans the surface three times in succession (this value canbe changed in Recall / Options / Recall Setup. This is in case anycontrols have been accidentally nudged when adjusting other controls).When the three scans are complete, no problems have been found and allChannels and the Monitor Section have been reset, a confirmationdialogue box will be displayed.The console is now completely reset according to the Recall Store that wasloaded.> Click OK.- 122 -