Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Online / Offline RoutingOn Line routing is enabled when the On-Line check box is ticked.• If On Line is enabled, the changes will appear on the consoleimmediately.• If On Line is disabled, the changes will not appear on the console(and the Apply button will be available).> If working in Offline mode, you can force the console to match routingchanges by clicking the Apply button.> To clear all settings for a single port, click on the System Name of therequired port in the Ports column, and click the Clear button.> To clear all settings for multiple ports, click and hold the mouse buttonon the first System Name of the ports to be cleared.Drag down the list until the last port to be cleared is selected, and releasethe mouse button.> Click the Clear button.> To clear multiple entries in a single column, click in the columncontaining the entries to be cleared.> Click and hold the mouse button on the first entry to be cleared.> Drag down the list until the last port to be cleared is selected. Releasethe mouse button, and click the Clear button.Quick PatchQuick Patch is used to assign all of the inputs or outputs for one path typeto a sequence of ports.> Click on the drop down arrow next to the path type box.The list of valid path types for use with Quick Patch will appear.> Click on the required path type.> Click on the drop down arrow next to the port type box, and the porttype list will appear.> Click on Input or Output as required.> Click on the drop down arrow next to the port names box, and the list ofavailable sets of ports will appear.> Click on the required port name, and click the Apply button.The selection will be applied to the current Desk Setup and allocated onthe console:• If there are more ports than paths then the remaining ports will beunused.• If there are more paths than ports then the remaining paths will becleared.If I/O Patching is not On Line then any modifications made on the pagesnot affected by the Quick Patch selection will be applied at the sametime as the Quick Patch is applied.> To exit I/O Patch, click on the Exit button in the bottom right handcorner of the I/O Patching window.Changes made to the porting are automatically saved on Exit, unless theMix Setup is read-only.- 179 -