Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1The lower window will show faders in red that have had automationremapped plus the source channel (in effect, the automation between thesource and destination is swapped).A red dot will appear on the numbered tabs in the lower window to showthat faders within that range have been affected.> To reset the mapping for a fader, click on the relevant fader in the lowerwindow, and both the source and destination automation will be returnedto their original faders.> Once the remapping is complete, click the Save & Use button.The Reassign Status will turn white and show Active.> Tick the Show Names box, and whenever the mouse is hovered over achannel, the user given (or default) name will be briefly shown as a smallfly-out display.> Alternatively, you can click on Templates, and be taken to the filingdialogue where you can Save, Load and Delete these Reassign templatesas you would any other file.Once the Reassign is active, a tick will be placed against ReAssign Activeon the Automation Menu.> Alternatively, you can click on Inactive, and a prompt will remind youthat current changes have not been saved.> Click Yes, to apply changes and turn Reassign on.> Click No to abandon changes but still turn Reassign on.> To clear the remapping selection entirely, click New.> Click Yes or No as desired.- 111 -