Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Offline Routing AssistantThe Offline Routing Assistant allows the user to set up internal pathroutes within a desk setup (including setting a route to be either pre- orpost-fade), and then import this setup.This means that all of the configurational work can be done on a remotePC and simply transferred into the system reducing the amount of setuptime needed on site.There are no limits to the blocks of routes that can be displayed.The Offline Routing Assistant is not meant for use on onlineconsoles.It is only meant to be used on offline laptops and computerswhere you need to set up the routing away from a console beforea session begins.On Online consoles, it is for display only and contains no settableoptions apart from displaying routes in place.> In the Configure menu, select Configure Blocks.This opens a screen asking the user which blocks of routes they wish todisplay.> Tick the blocks you wish to view, and click OK.> To view all blocks, tick the first option, and then drag the mouse toselect all.> Once the chosen blocks have been displayed, you can create a route byclicking in the junction of the two paths.All routes are created post-fader (and shown as orange squares), but byright-clicking on a route already in place, the route can be sent pre-fadeand will be shown in green.The source of the route is always displayed down the left side of thescreen, while the destinations are displayed along the top.Due to limitations of space, any paths that the user has renamed will onlyappear on Source routing.> Even though the user names are not displayed across the top, if youpoint at the junction of two paths, a small flyout menu will tell you whichpaths you are currently pointing to, including any user names for thosepaths.- 219 -