Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1> To select the path type or meter group to place, click on the radiobutton for the required path type or meter group.The list box will show the selected paths or meter groups.If split console mode is in operation then there will be one set of WildMeters and PreDubs available for each console partition.The names reflect the console partition the meters are applicable to (i.e.Wild 1 represents the Wild Meters in partition 1, etc.).If Stems is selected then Stems A to F will be listed, plus an option forFilm which represents the Film monitor outputs.> Use the scroll bar to view additional paths in the list.> To place a path or meter group, click and hold on the required item inthe list (the pointer will change to indicate drag and drop mode. Drag 'n'drop onto the required meter).The path or meter group name will appear in the box underneath themeter.The default meter type for the item will appear at the top of the meter.Other options will appear below the meter.If a Group item was selected then the requisite number of meters will beallocated (4 for Wild Meters, 8 for Stems or PreDubs).Wild Meters will automatically snap to use the whole of the quadstripthey are dropped onto.Stem and PreDub meter groups will automatically snap to the set ofeight meters they are dropped onto. (i.e. they will snap to meters 9 to 16when dropped onto meter 15).If a meter was already allocated then a dialogue box will appear toconfirm re-assignment of the meter.To assign paths on a layer> Click the Meter Follow Path button.A flyout menu with follow options will appear.> Click the Assign Paths Currently Under A Meter option.The Auto Assign By Layer dialogue box will be displayed.> Click A, B, C or D for the required layer, and click OK.The paths assigned to the selected layer will be assigned to thecorresponding meters.> To automatically set meters to follow layer selection, click the MeterFollow Path button.A flyout menu with follow options will appear (as above).> Click the Make Meters Always Follow Selected Path option.- 184 -