Encore Two User Manual - AMS Neve

Encore Two User Manual Issue 1Copy Path DataCopy Path Data is used to copy automation data in the current Play Passfrom one path to any other path(s) (including itself).It could be used, for example, for copying chorus automation data fromone section of a song to another.A timecode range can be specified and the destination timecode can beoffset.Once copied, a new Mix/Pass is created and becomes the current PlayPass.> First, select the correct Mix/Pass from the Mix/Pass Tree or use LoadMix if the current Play Pass does not contain the required automationdata.There are three tabbed pages for Times, Path Selection and CopyMode. The Times page will be on top.> To set the source and destination timecodes, click on the Source Start,Source End and Destination Start timecode, and click on the Label withthe appropriate timecode (this can then be adjusted manually).If all the timecodes are left at zero then all of the automation data fromthe source path will be used.> To set the Source and Destination paths, click the Set Paths tab.> Click on the required source path in the Source list, and the path willbe highlighted (you can only set one source path).> Click on the required paths in the Destination list, each selected pathwill be highlighted.> The Select All and Deselect All buttons can be used to reset theselection if it is necessary to start again.> To set the Copy modes, click on the Modes tab.> Click the Faders, Mutes, etc. check boxes to select which parts of theautomation data to copy (at least one item must be checked in theInclude box).> Enter the required crossfade time in the xFade Time box.(Pass Selection is not currently implemented).> To create the new Mix/Pass, click on OK.The data will be copied as selected and the window will close.The new Mix/Pass number will be shown as the current Play Pass on themain screen.- 45 -