Standard for Fire Safety in Rapid Transit Systems - Singapore Civil ...

More documents

Recommendations

Info

APPENDIX E - continue Diagram E.1 ACCESSWAY (WHEELS & JACKS LAYOUT) 5384mm Wheel Spacing Standard for Fire Safety in Rapid Transit Systems E-2
APPENDIX F STANDBY FIRE HOSE FOR RISING MAIN F.1 Type and folding method F.1.1 The standby fire hose shall be of 63.5mm nominal internal diameter in order to ensure that the hose coupling will fit existing coupling tail pieces. The hose shall be rugged and capable of carrying water under substantive pressure in accordance with BS 6391. The fire hose shall be of type 3 as stipulated in BS 6391. F.1.2 The fire hose couplings shall be manufactured to BS specification or equivalent and of light alloy or gunmetal. The coupling shall be of type 63.5mm and be of the instantaneous type with standard (double-pull) release mechanism. The couplings shall be tied in by binding with galvanised mild steel wire and applied over a hose guard of synthetic fibre. It shall be able to withstand a minimum working pressure of 15 bars. F.1.3 Each hose shall have a standard length of 30m and shall be kept stowed in a Dutch Rolled position and housed in a glassfronted cabinet. F.2 Position F.2.1 The fire hose shall be installed just next to, but not more than 2m from the landing valve. F.2.2 The entire fire hose and cabinet shall be out of direct sunlight. F.3 Mounting The wall mounted fire hose cabinet requirement shall be as follows: (i) The cabinet shall be firmly mounted on the wall and rigid to take either one or two fire hose weight. (ii) The cabinet shall be constructed of non-combustible material. (iii) The cabinet lock, if provided, shall be of the type that could be operated manually from the inside without the use of a key when the front plain glass/plastic (minimum 300mm x 300mm) is broken by the fire fighter. Type Hose couplings Storage Fire hose cabinet Standard for Fire Safety in Rapid Transit Systems F-1
Page 1 and 2:
Standard for Fire Safety in Rapid T
Page 3 and 4:
2.3.13 Restriction of Spread of fla
Page 5 and 6:
SECTION 3.2 - OCC and RTS Facility
Page 7 and 8:
1.1.4 ABBREVIATIONS The abbreviatio
Page 9 and 10:
2.1.2.5 Area of Refuge (a) In the s
Page 11 and 12:
2.1.2.16 A space enclosed by elemen
Page 13 and 14:
2.1.2.27 A means of egress from the
Page 15 and 16:
2.1.2.45 The height of station or (
Page 17 and 18:
2.1.2.64 An enclosed space that is
Page 19 and 20:
2.1.3 STATION OCCUPANCY 2.1.3.1 The
Page 21 and 22:
CODE Table 2.1.3 APPROVED TRADES AN
Page 23 and 24:
SECTION 2.2 STATION MEANS OF ESCAPE
Page 25 and 26:
2.2.3 MEANS OF ESCAPE FROM PLATFORM
Page 27 and 28:
2.2.3.9 Gate-type emergency exits s
Page 29 and 30:
2.2.4.7 The maximum travel distance
Page 31 and 32:
(iii) Permanently fixed ventilation
Page 33 and 34:
(h) 850mm for doors and gates, and
Page 35 and 36:
300 mm (iii) The sign shall be loca
Page 37 and 38:
(d) Exit ramps shall be straight wi
Page 39 and 40:
(d) Ventilation 2.2.5.12 ESCALATORS
Page 41 and 42:
(ii) All exit access doors which op
Page 43 and 44:
2.2.5.14 FARE COLLECTION GATES AND
Page 45 and 46:
2.2.5.19 Photo luminescent marking
Page 47 and 48:
Diagram 2.2.4.4 - Means of escape f
Page 49 and 50:
Diagram 2.2.5.13(e) - Exit doors sh
Page 51 and 52:
Diagram 2.2.5.16(a)(v) - Remoteness
Page 53 and 54:
SECTION 2.3 STATION STRUCTURAL FIRE
Page 55 and 56:
2.3.1 GENERAL SECTION 2.3 STATION S
Page 57 and 58:
(c) Commercial spaces shall be comp
Page 59 and 60:
(h) Coldroom Where the enclosure to
Page 61 and 62:
(b) Any reference to height means t
Page 63 and 64:
2.3.5 EXTERNAL WALL 2.3.5.1 Externa
Page 65 and 66:
2.3.6.2 A separating wall shall hav
Page 67 and 68:
(b) Have the appropriate fire resis
Page 69 and 70:
2.3.8.8 A protected shaft which con
Page 71 and 72:
(ii) Drywall shall have the requisi
Page 73 and 74:
2.3.9.3 Pipes (a) Pipes which pass
Page 75 and 76:
2.3.10.3 Doors opening into the exi
Page 77 and 78:
(h) All sides shall be properly sea
Page 79 and 80:
(v) Intumescent mastics. The method
Page 81 and 82:
(e) Cl.2.3.8.2(c), 2.3.8.4, 2.3.8.7
Page 83 and 84:
Table 2.3.2A SIZE LIMITATION OF STA
Page 85 and 86:
Table 2.3.9A MAXIMUM NOMINAL INTERN
Page 87 and 88:
Diagram 2.3.3.1(c) - Fire resistanc
Page 89 and 90:
2.4.1 GENERAL SECTION 2.4 SITE PLAN
Page 91 and 92:
ii) For stations not exceeding the
Page 93 and 94:
2.4.4 PRIVATE FIRE HYDRANT 2.4.4.1
Page 95 and 96:
(c) Where there are more than one p
Page 97 and 98:
Diagram 2.4.2.4(b)(vi) U-Turn Radii
Page 99 and 100:
Diagram 2.4.4.1(b) - Provision of P
Page 101 and 102:
S2.5.3 Fire protection systems to c
Page 103 and 104:
2.5.2.5 Portable fire extinguishers
Page 105 and 106:
2.5.3.5 The dry mains’ breeching
Page 107 and 108:
2.5.5.2 The fire alarm system shall
Page 109 and 110:
2.5.6 SPRINKLER INSTALLATION 2.5.6.
Page 111 and 112:
2.5.7 LIFTS 2.5.7.1 Lifts (includin
Page 113 and 114:
SECTION 2.6 STATION SMOKE CONTROL A
Page 115 and 116:
2.6.1 GENERAL SECTION 2.6 STATION S
Page 117 and 118:
(e) Where the supply air duct servi
Page 119 and 120:
(c) The smoke purging system design
Page 121 and 122:
2.6.5.2 The design shall encompass
Page 123 and 124:
Diagram 2.6.1.4(a) - Fresh/exhaust
Page 125 and 126:
S2.7.2 Provisions for adequate and
Page 127 and 128:
(b) Notwithstanding the requirement
Page 129 and 130:
(g) Exit signs in metal enclosures
Page 131 and 132:
2.7.2.10 PA systems for stations wi
Page 133 and 134:
(c) Supply air shall be drawn direc
Page 135 and 136:
2.8.1 GENERAL SECTION 2.8 INTEGRATI
Page 137 and 138:
2.8.4.2 Where a station has an unde
Page 139 and 140:
SECTION 2.9 UNDERGROUND OR ENCLOSED
Page 141 and 142:
S2.9.10 Provisions for ventilation
Page 143 and 144:
2.9.2.3 Where underground or enclos
Page 145 and 146:
2.9.3.5 The emergency lighting shal
Page 147 and 148:
2.9.6.3 An engineering analysis is
Page 149 and 150:
2.9.8 MOTORISED TROLLEY 2.9.8.1 Mot
Page 151 and 152:
Diagram 2.9.4.2 - Numbering and lab
Page 153 and 154:
ROOT OBJECTIVES SECTION 2.10 ABOVEG
Page 155 and 156:
2.10.3 EMERGENCY ACCESS 2.10.3.1 Em
Page 157 and 158:
PART III - RTS DEPOT AND RELATED FA
Page 159 and 160:
(g) The maximum travel distance for
Page 161 and 162: Diagram 3.1.1(d) - Element of Struc
Page 163 and 164: For RTS Facility Buildings S3.2.5 P
Page 165 and 166: PART IV - ELECTRICAL SYSTEM FOR RAP
Page 167 and 168: 4.1.3.2 Not withstanding the above,
Page 169 and 170: APPENDIX A OCCUPANT LOAD CALCULATIO
Page 171 and 172: A.2.3 For a single service centre p
Page 173 and 174: A.3.3 For a multi-service centre pl
Page 175 and 176: 1 2 3 4 5 APPENDIX A, TABLE A : SIN
Page 177 and 178: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Page 179 and 180: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Page 181 and 182: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Page 183 and 184: Number of People APPENDIX A, FIGURE
Page 185 and 186: B.1 GENERAL APPENDIX B EXITING ANAL
Page 187 and 188: any enclosing structure for Escape
Page 189 and 190: TEST #2 FOR ESCAPE ROUTE 2 TOTAL WA
Page 191 and 192: A. Masonry construction - continued
Page 193 and 194: APPENDIX C - continued PART II : RE
Page 195 and 196: 1. Dense concrete: APPENDIX C - con
Page 197 and 198: APPENDIX C - continued PART V : STR
Page 199 and 200: APPENDIX C - continued PART VIII :
Page 201 and 202: Width of enclosing rectangle in met
Page 211: APPENDIX E ACCESSWAY E.1 In general
Page 215 and 216: G.1 General APPENDIX G TENABLE ENVI
Page 217 and 218: where: tIconv = time in minutes T =
Page 219 and 220: APPENDIX H NOTES ON THE USE OF INTU
Page 221 and 222: APPENDIX J FIRE SAFETY REQUIREMENTS
Page 223 and 224: J.5.3 In the event of fire emergenc
show all

Standard for Fire Safety in Rapid Transit Systems - Singapore Civil ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?