UCS 2.4 - Univention

Figure 3.3: Partitioning hard drives
3.2 Text-based Installation
procedure only if all existing logical LVM media were deleted via the installer beforehand. Otherwise
the contents of the physical LVM medium have to be manually moved to other physical LVM media
via the pvmove command, and the physical LVM medium then removed from the LVM media group
and deleted, via the vgreduce and pvremove commands.
The settings for a new partition are not immediately activated. The [F5-Reset changes] button (F5
function key) can be used for restoring the previous settings. Only if the [F6-Write partitions] button
(F6 function key) is used, will the new partition table be written to the hard drive.
11. Boot loader
In this dialogue box you can select whether the boot loader should be installed in the master boot
record (MBR), or in the first sector of a bootable hard drive partition. If the UCS system is the only
operating system installed on the computer, then the master boot record and the corresponding hard
drive should be selected here.
12. Network configuration
With the first execution of the network configuration, a dialogue box will open which allows you to
make the settings for the first detected network interface card.
If the DHCP option was not chosen, the IP address to be bound to the network card must be entered.
In addition to the IP address the net mask must also be entered. F5 DHCP request is used to
request an address from a DHCP server. This is used as the default and can also be configured
statically.
Once the first network card is set up, further network-specific settings can be made. The IP address
or full name of the standard gateway present in the subnet can be entered in the field Gateway.
31