08.01.2013 Views

Steel Designers Manual - TheBestFriend.org

Steel Designers Manual - TheBestFriend.org

Steel Designers Manual - TheBestFriend.org

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

This material is copyright - all rights reserved. Reproduced under licence from The <strong>Steel</strong> Construction Institute on 12/2/2007<br />

To buy a hardcopy version of this document call 01344 872775 or go to http://shop.steelbiz.<strong>org</strong>/<br />

<strong>Steel</strong> <strong>Designers</strong>' <strong>Manual</strong> - 6th Edition (2003)<br />

944 Tolerances<br />

Table 31.5 (contd )<br />

©BCSA<br />

9.6.7 Beam Level Specified<br />

Level A<br />

Deviation from specified level at<br />

supporting column.<br />

9.6.8 Level at Each End of Same Beam<br />

Relative deviation in level at ends.<br />

9.6.9 Level of Adjacent Beams within<br />

a distance of 5 metres<br />

I<br />

J<br />

A = 10mm<br />

A =5mm<br />

Deviation from relative horizontal<br />

levels (measured on centreline of<br />

top flange). A = 5mm<br />

9.6.10 Beam Alignment<br />

Horizontal deviation relative to an [I<br />

Floor<br />

Level<br />

adjacent beam above or below. A<br />

Floor<br />

Level<br />

h3m, A=h1600

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!