Expression 3 - ETC

Adding, deleting and modifying channels
Follow these steps to edit channels in a multipart cue:
Keystrokes:
Action:
1. Press [Blind]. Selects Blind display mode
2. Enter the cue number. Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [Part], then press [+]
or [–] until the desired part
is displayed.
4. Press [Channel], and
select the desired
channels.
5. Set channel levels. Press
[At] [Clear] to delete the
selected channels.
6. Press [Record] [Part] [2]
[Enter].
Prompt reads:
Select part number
Prompt reads:
Select channel numbers
If the channels are new, this adds
them to the part at the level indicated.
If already in the part, this modifies their
level
Records the changes into part 2 of the
cue
Using Update
With Update, you can do live editing of cue parts in Stage and Fader and
see the results immediately on stage. Use the procedure below to add
channels and set levels, assuming you previously created multipart cue 1.
Keystrokes:
Action:
1. Press [Stage] Selects stage display
2. Press [S8], Fixture, [4] Selects fixture 4
3. Set intensity, pan and tilt
levels.
4. Press [S2], Update. Prompt reads:
To update cue, select number and
press ENTER (TRACK + ENTER for
tracking)
To cancel, press CLEAR
5. Press [Cue] [1]. Selects multipart cue 1 to update
6. Press [Part] [2] [Enter]. Updates part 2 of cue 1
122 Chapter 9 Multipart cues