Expression 3 - ETC

Setting and unsetting dimmers
If your console is connected to an ETC Sensor dimming system by an
ETCLink network, you may use your console to set and unset dimmers at
the dimmer rack.
Note: For more information on setting dimmers, see the Sensor CEM
User Manual.
Setting a dimmer
To set a dimmer or group of dimmers to a level at the dimmer rack,
ignoring any DMX512 outputs, follow these steps:
Keystrokes:
Action:
1. Press [Setup]. Selects Setup display
2. Press [9], ETCLink
Functions, [Enter].
Selects ETCLink Functions menu
3. Press [S7], Set Dimmer. Prompt reads:
Select dimmer number(s) to set,
then press ENTER
(To cancel, press CLEAR)
4. Enter the dimmers you
wish to set and press
[Enter].
5. Enter the level at which to
set the dimmers. Enter in
two-digit form (e.g., one
percent = 01)
Prompt reads:
Select dimmer level
(Press FULL button for 100%)
Advisory reads:
To confirm, press ENTER
To cancel, press CLEAR
6. Press [Enter]. Dimmers are set to desired level
Unsetting a dimmer
To unset a dimmer (or group of dimmers) and return it to normal operation,
follow the procedure below. (NOTE: Setting a dimmer to level 00 is not
the same as unsetting it and returning it to normal operation.)
Keystrokes:
Action:
1. Press [Setup]. Selects Setup display
2. Press [9], ETCLink
Functions, [Enter].
3. Press [S6], Unset
Dimmer.
4. Enter the dimmers you
wish to unset and press
[Enter]. Press [0] [Enter] to
unset all set dimmers.
Selects ETCLink Functions menu
Prompt reads:
Select dimmer number(s) to unset,
then press ENTER
(Enter 0 to unset all dimmers)
Prompt reads:
To confirm, press ENTER
To cancel, press CLEAR
5. Press [Enter]. Dimmers are unset
276 Chapter 23 Dimmer monitoring