Expression 3 - ETC

Follow these steps to create a macro to record a show to diskette:
Keystrokes:
Action:
1. Press [Setup]. Selects Setup display screen
2. Select 8, Macro Editing,
and press [Enter].
Selects Macro display screen
Prompt reads:
Select macro number, then press
ENTER
3. Press [8] [Enter]. Blank macro created
Prompt reads:
Select operation(s) for this macro –
press ENTER MACRO when done
(Wheels, trackpad and sliders are
not valid entries in macros)
4. Press [Setup] [3] [Enter]. Enters setup display
Macro contents line reads: SETUP 3
ENTER
5. Press [1] [Enter]. Selects Write Show To Disk
Macro contents line reads:
SETUP 3 ENTER 1 ENTER
6. Press [Enter]. Confirms selection
Macro contents line reads:
SETUP 3 ENTER 1 ENTER ENTER
7. Press [Enter Macro]. Stores macro 8
Macro wait
To program a pause in the macro, press [Macro Wait] at the point in the
macro where you want the pause to occur. Enter the time you would like
the macro to hold, then press [Enter]. Continue to enter remaining macro
commands.
Times may be expressed in minutes and seconds, or as fractions of seconds
(in decimal format). Times can be programmed from 0.1 seconds to
99:59 minutes. Acceptable time values include: 0.2 (.2 seconds), 00:12
(12 seconds), 5.5 (5.5 seconds), or 5:30 (five minutes, 30 seconds).
Expression 3 User Manual, v.3.1 237