Expression 3 - ETC

Editing a subroutine
To edit a subroutine, select the step you wish to change by pressing [S1],
Step, and entering the step number. Use [And] and [Thru] to select
multiple steps. 24 You can either use softkeys to find your way around the
Step Display or navigate with other console controls, as shown in the
following table.
Navigation and Feedback - Step Display
[S] ±
Select a step X X X X
Select a field X X
White row
Yellow field
selected step
selected field
The softkeys available in the display are as follows.
[S2], Style
Allows you to select a style from the
style menu.
[S3], Select Cue
Allows you to enter a cue number for the
selected step.
[S4], Type/Level
Allows you to select a crossfade or an allfade
and to set intensity level.
[S8], Up/Down/Follow Allows you to set upfade and downfade
times and to set follow time.
Once you finish editing the subroutine, press [Record] [Enter] to save your
changes.
Deleting a step
Press [S6], Delete Step, and enter the step number. Then press [Enter].
The console deletes the selected step and renumbers the remaining
steps.
Inserting a step
Press [S1], Step, and enter the step number where you want to insert the
new step. Then press [Enter]. The console inserts a blank step before the
selected step.
24.
If you select a range of steps, only cue steps will be selected. Style
steps may only be edited individually and will be left out of selected
ranges.
232 Chapter 17 Subroutines