Expression 3 - ETC

Clear Loads procedure
Clear Loads allows you to clear recorded loads information for selected
dimmers, thus disabling dimmer monitoring for those dimmers. This can
be useful if you know that the load on a dimmer or group of dimmers will
change over the course of a show and don’t want to receive load error
messages every time it happens.
To clear recorded loads, follow these steps:
Keystrokes:
Action:
1. Press [Setup]. Selects Setup display
2. Select [9], ETCLink
Functions, and press
[Enter].
Selects ETCLink Functions menu
3. Select [4], Load
Management, and press
[Enter].
4. Press [S6], Clear Loads.
(If you wish, you may
enter a specific dimmer or
dimmers to clear.)
Selects Load Management display
Prompt reads:
To clear loads, select dimmer(s) and
press ENTER (Enter 0 to clear nonzero
loads for all dimmers)
5. Press [0] [Enter]. Advisory reads:
Recorded loads will be erased for all
dimmers with levels above zero,
disabling load error messages for
those dimmers.
6. Press [Enter] to proceed
with the load clear, or
press [Clear] to cancel the
operation.
Press [Enter] to proceed, or press
[Clear] to cancel
Loads are cleared for all dimmers with
levels above zero
Expression 3 User Manual, v.3.1 275