Expression 3 - ETC

Auto channel check
This macro automatically runs through each channel with a two second
wait between each channel, beginning with channel 1. You can effectively
pause the check by cancelling the macro at any channel. If you replay the
macro after the cancellation, the check begins at the next channel in
sequence.
[At] [0] [Enter] [+] [Full] [Macro Wait] [2] [Enter] [M#]
Macro line reads: At 0 Enter + Full Mwait2 M#
(# = this macro’s macro number)
Turn off all lights except work lights
This macro captures all channels and sets them to zero. This overrides all
faders and submasters. Then the macro sets work lights at full. You can
easily return to previous settings by pressing [Rel] to release captured
channels.
[Channel] [1] [Thru] [–] [At] [0] [Enter] [#] [Full]
Macro line reads: Chan 1 Thru - At 00 Enter Chan # Full (#=work
lights channel)
Clear faders and turn work lights on
This macro clears both faders and selects work lights.
[Clear AB] [Clear CD] [Channel] [#] [Full]
Macro line reads: Clear-AB Clear-CD Chan # Full
(#=work lights channel)
Clear unused channels in Flexichannel mode
This macro clears channels that are visible, but no longer in use. (Because
this macro uses a softkey, you must create it using Learn.)
[Setup] [1] [Enter] [S1] [Stage]
Macro line reads: Setup 1 Enter PurgeFlexi Stage
Record show on disk
This macro records the current show on disk.
[Setup] [3] [Enter] [1] [Enter] [Enter]
Macro line reads: Setup 3 Enter 1 Enter Enter
Expression 3 User Manual, v.3.1 243